Service And Maintenance; Limited Warranty - Xylem JABSCO 60233 Manual

LEARNING MODE PROCEDURE
Note: The controller included with this product was initialized at the
factory to communicate with the searchlight. It is not necessary to
conduct this procedure unless adding or replacing a
controller.
a. Disconnect battery power to the searchlight.
b. Disconnect power to the transmitter.
c. Re-connect power to transmitter.
d. Press and hold the "on/off" button and the left
directional arrow on the controller while
reconnecting power to the searchlight. The
searchlight will turn "on" within (2) seconds.
e. Code synchronization is then complete.
LEARNING ADDITIONAL CONTROLLERS TO THE UNIT
The Jabsco 233SL can support up to (4) separate controllers. Each
time a controller is added to the system, or is replaced, all controllers
require re-initialization using the above procedure. Power to the
searchlight must be disconnected then reconnected while pressing
the controllers "on/off" button for each controller added.
A Searchlight
B Controller
C Circuit Breaker / Fuse Block
D Battery
E Additional Controllers (3 Max.)
CLEANING OF EXTERIOR SURFACES
Recommendation for cleaning exterior surfaces is a solution of warm
water and a mild detergent soap.
CAUTION!
Do not use cleaners that contain esters, halogenated
solvents, aromatic solvents, ketones and strong acids
or bases.
CAUTION! - BURN HAZARD
Burn hazard. Do not touch lens when light is "on".
SERVICE & MAINTENANCE
The 233 Searchlight carries a one year warranty starting from the date
of purchase. Any defects within this first year will be handled by
Jabsco and repaired at no charge to the customer. For service and
defects beyond the one year warranty period, please contact Jabsco
for information and pricing on service replacement parts. Due to the
complexity of this product all servicing and parts replacement will be
carried out either at the factory or a Xylem recognized service center.

LIMITED WARRANTY

Xylem – Jabsco ("Xylem") warrants that at the time of shipment the
product manufactured by Xylem and sold hereunder ("the product")
shall be in conformity with applicable written specifications and
descriptions and will be free from defects in material and workmanship
for a period of 1 year or period stated on the product packaging. The
warranty will not extend to a product which becomes defective
resulting from damage in the course of transportation or by storage
operation use or maintenance in an environment not conforming to the
instructions or specifications of Xylem or if the product is altered or
modified in any way.
Xylem's sole liability for breach of this warranty will be (at its option) to
repair or replace the defective product. Warranty is only valid with
proof of purchase from an authorized Xylem dealer.
Please note that the warranty on the product is with the place of
purchase. For further information on Xylem warranties or to make a
warranty claim please contact your local Xylem representative or visit
our website at: www.jabsco.com
WIRING SCHEMATICS KEY
BLK
425