Installation & Set Up Instructions - Xylem JABSCO 60233 Manual

SEARCHLIGHT FUNCTION AND OPERATION
WIRELESS RANGE PERFORMANCE
The 233SL wireless controllers are tested in real life marine
conditions. The lights are installed in both coach roof and on the bow
locations with primary controllers located in the wheel house and
secondary controllers in various other locations. The results show no
loss of interference between the light and the controller performing as
required. Laboratory testing has shown no loss of performance in line
of sight conditions at 100ft. Additional laboratory testing with the light
and controller communicating through obstructions at 50ft.
shown no loss of performance.
INSTALLATION & SET UP INSTRUCTIONS
The installation instructions include 3 stages of set up.
They Include:
1: Mounting the light
2: Mounting the contoller
3: "Learning" the controller to the light
For further information on mounting additional control stations,
please see page 3 of this datasheet .
8-Way Controller
The 8 way controller gives faster times to
target than 4-way controllers by moving
across all diagonals.
Horizontal Range
The horizontal range for this light is a
continuous 360 degrees.
Vertical Range
The vertical range for this light is 27
degrees. Nine from the center line to full
up and 18 from centerline to full down.
Auto Sweep
With the light on in either fast or slow
mode, the light will continuously sweep the
light 10 degrees each side of the initial
target spot. If the light is in fast mode, it will
automatically place the unit into slow
mode. Simply press the auto sweep button
again to finish the cycle. The light will
return to its initial starting point and the
directional controls will become available
.
for use again
Speed
The 233SL has the option of running all
motion axis in FAST or SLOW mode. For
fast simply hit the Hare button and for slow,
the Tortoise Button.
Spot / Flood
The spot and flood buttons allow the beam
configuration to change from a spot to a
flood, or any beam configuration between
these two extreme limits. Simply hold one
of the buttons down until you reach the
desired beam configuration. For full spot or
flood, hold the spot or flood button down
until it comes to a complete stop.
embossed
embossed on
size to ma
embossed
size to match
icons are als
icons are also
included as
included as AI
symbols (wh
symbols (whit
has
emboss