Advertisement
14
14
Carefully stand your unit upright.
Separate the EXTENSION SLIDES (Z) from the EXTENSION RAILS (Y) as shown in the upper diagram. Be prepared, the parts are
greasy.
Fasten the EXTENSION RAILS (Y) to the DRAWER UPRIGHTS (E) and UPPER UPRIGHT (D). Use eight GOLD 5/16" FLAT
HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the UPRIGHTS. Turn a SCREW into this hole.
Page 18
Z
Push the release lever in and pull the SLIDE from the RAIL.
E
Y
Y
www.sauder.com/services
3S
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
Y
D
Open end
Y
E
Y
Open end
414405
Advertisement
