Advertisement
Troubleshooting
PROBLEM
Slow water flow rate
Small amounts of black
particles in water tank
START/STOP
Button does not
respond
Leakage from water
tank
Odd taste of the water
"FILTER RESET"
Indicator light flashing
If you cannot remedy problems by using the troubleshooting chart above, contact Breville
Customer Service.
POSSIBLE CAUSE
•
Aging of pump or inlet at the base of
the unit is clogged
•
These are small pieces of carbon from
the filter. These carbon particles are
food grade and are not harmful. They
will not impair the performance of
your filter or unit.
•
The unit is not connected to the
power
•
The water tank is filled beyond the
maximum water level
•
Tank is not firmly pushed into
position
•
The filtered water has not been used
for a long time
•
The filter has reached end of life
•
Filter needs to be changed or filter
reset has not been actioned
WHAT TO DO
•
Contact Breville Customer Service
•
Flush your unit and water filter
cartridge. Refer to 'Flushing the
Breville AQUASTATION™' (page
12) and 'Preparing the Activ360
Filter' (page 12)
NOTE: Some carbon fibre residual
may still be present after flushing
the unit and filter.
•
Plug in to a usable power outlet
and turn power on
•
Ensure water is only up to the
MAX water level marking. If
leakage continues, please contact
Breville Customer Service
•
Replace the water tank, pressing
down to ensure that it is properly
positioned and attached to the
unit.
•
Discard the remaining water in the
water tank and refill with fresh tap
water. Depending on the length
of time, the filter may require
re-flushing
•
Replace with new filter
•
Change the filter if required, turn
the FUNCTION dial to "FILTER
RESET" and press the START/
STOP button once to reset.
19
Advertisement
