Connecting A Kenwood Sovereign Receiver; Connecting Any Other Primary Receiver - Kenwood Sovereign Entre Install Manual

How Do I Connect to My Receiver or Amplifier?, continued
Do not plug in Entré or devices to AC power until you have connected all your
devices.
This section focuses on the connections from your receiver to Entré. Please refer
to your receiver's instructions for more detail about its connection jacks and
capabilities.

Connecting a Kenwood Sovereign Receiver

Review the information under "Before making any video connections to the
TV". It contains important notes about the types of connections you can make.
1. Connect one of the included optical digital cables from the receiver's OPTI-
CAL DIGITAL Out jack to Entré's DITIGAL OPTICAL In jack and connect
the other included optical digital cable from Entré's DIGITAL OPTICAL Out
jack to the receiver's CD-R OPTICAL DIGITAL jack, as shown.
If you use the optical digital cable, be sure to remove the
protective cover from the optical jack before connecting.
Please retain the cover and store it in a safe place.
2. Connect the video cable from the receiver's MONITOR OUT jack to Entré's
Video Input jack as shown. Use the same type of connection that you used
between Entré and your TV (see pages 2-3).
3. Connect the included RS-232C cable from the receiver's RS-232C jack to
Entré's RS-232C jack as shown.
The RS-232C cable included with Entré has female
connectors at both ends. If you are substituting a commercially
available RS-232C cable, make sure that it has female
connectors on both ends.
4. Connect one stereo audio cable from the receiver's CD-R REC OUT jacks
to Entré's ANALOG REC IN jacks. Connect another stereo audio cable from
Entré's ANALOG PLAY OUT jacks to the receiver's CD-R PLAY IN jacks as
shown.
If you don't use Entré's analog connections, you may not be
able to record certain copy-protected media that can only be
recorded using Entré's analog inputs.
How to Connect and Set Up Your Entré Entertainment Hub
How Do I Connect to My Receiver or Amplifier?, continued

Connecting Any Other Primary Receiver

1. Examine the receiver's available inputs and outputs. Select an input set for
Entré that has an optical digital input, analog play (tape monitor) outputs,
and analog record (tape monitor) inputs associated with it. Note which
input you select: this will become the receiver's Entré input.
2. Connect a stereo audio cable from the receiver's TAPE MONITOR OUT
(Rec) jacks to Entré's ANALOG REC IN jacks. Connect another stereo audio
cable from Entré's ANALOG PLAY OUT jacks to the receiver's TAPE MONI-
TOR IN (Play) jacks.
3. Connect a digital optical cable from Entré's DIGITAL OPTICAL OUT jack to
the receiver's DIGITAL OPTICAL IN jack. If the receiver has a DIGITAL
OUT jack, and depending on what type it is (either coaxial or optical), con-
nect it to one of Entré's DIGITAL IN jacks.
If you use the optical digital cable, be sure to remove the
protective cover from the optical jack before connecting.
Please retain the cover and store in a safe place.
4. Connect a video cable from the receiver's video MONITOR OUT jack to
Entré's VIDEO INPUT jack. Use the same type of connection that you used
between Entré and your TV (see pages 2-3).
Do NOT plug Entré's power cord into the receiver's switched
accessory outlet. Plug Entré's power cord only into a wall
outlet that receives constant power.
5