Installation Instructions; Tools And Materials Required; Before Beginning Installation - GE PNRQ20RBL Owner's Manual & Installation Instructions

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit www.GEAppliances.ca
WARNING:
personal injury or property damage.
• Check with your state and/or local public works department for plumbing codes. You must follow their
guides as you install the Water Filtration system.
NOTE: Failure to comply with these installation instructions will void the product warranty, and the
installer will be responsible for any service, repair or damages caused thereby.
TOOLS AND MATERIALS REQUIRED FOR
INSTALLATION
• Electric drill and 1-1/4" Drill Bit (type as required)
if mounting is needed for faucet
• Two (2) Adjustable Wrenches
• 1/16" Drill Bit (optional for pilot holes)
• Tape Measure
• Phillips and Flat Blade Screwdrivers
• Utility Knife
• If your main water line is a rigid pipe,
you will require a compression fitting
and possibly other plumbing hardware
to complete the installation.
IMPORTANT
— To avoid damaging the
sink, consult a qualified plumber or installer for
drilling procedures. Special drill bits may be needed
for porcelain or stainless steel.
CONTENTS INCLUDED
WITH PRODUCT
• Reverse Osmosis Assembly and Tubing
• Product Literature (Owner's Manual and

Installation Instructions)

• Performance Data Sheet
• Feed Water Adapter
• Faucet Assembly with Electronic Base Monitor
and Tubing
• Storage Tank
• Drain Line Adapter
• Sanitation Canisters
Reverse Osmosis Filtration System
Read entire manual. Failure to follow all guides and rules could cause
Models PNRQ20RBL, PNRQ21RBN, PNRQ21RRB

BEFORE BEGINNING INSTALLATION

Read these instructions completely
and carefully.
IMPORTANT
•
for local inspector's use.
IMPORTANT
•
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Proper installation is the responsibility
of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• A shutoff valve must be available or added near
the installation point.
7
— Save these instructions
— Observe all governing