Download Print this page

Campania International Mini Element with Zen Frog Fountain FT-253 Assembly Instructions

Advertisement

Quick Links

FOUNTAIN INFORMATION:
This fountain holds approximately 1/2 gallon of water.
No recommended fountain covers are available for this
fountain.
No refill device or submersible lights are suggested for
this fountain
Fountain bowls/tops and other fountain components, which collect water, should not be left outside in the winter since any component
that fills with water and freezes may crack. Likewise, components such as pedestals, which remain in a basin, filled with water, which
then freezes, may also crack or crumble. Ideally, therefore, a fountain should always be stored indoors or in a dry protected place such
as a covered porch away from the elements. However, if a fountain must be left outside:
(1) Remove pump, stoppers, drainpipes, finials, and other small components for storage indoors. Note that stoppers or drain
pipes are removed to allow drainage in the event water accumulates in any basin.
(2) Raise fountain base from ground with wood strips so that base will not freeze to the ground surface.
(3) Cover or wrap the fountain with burlap or other absorbent material (old blanket or towel) and then cover securely with
plastic, making sure that water will not accumulate in the basin or other fountain component and freeze;
(4) Check fountain periodically to insure that plastic is secure and water is not accumulating in any fountain component.
Install fountains on a level surface. You will need a properly grounded 110-volt (AC only) GFCI protected receptacle near the
fountain for your pump. All pumps are submersible and must be completely underwater to function properly. Test all pumps and
adjust to full output prior to assembly. It is not recommended that fountains be placed directly on grass or dirt. Position the channel
opening at the base of each fountain toward the electrical outlet to be used since the pump
cord will be threaded through this opening.
Check out YouTube for a "How to" video.
For more Campania product information visit www.campaniainternational.com
FT-253 Mini Element with Zen Frog Fountain
- W I N T E R C A R E -
- G E N E R A L F O U N T A I N T I P S -
Pump Kit Parts List
PK120-LV pump with transformer (1)
Approx. 6" length of 1/2" black non-kink tubing (1)
Aluminum spiller/insert (1)
Hose clamps (3) *
Adhesive Dots (4)
* Hose clamps may be used as flow restrictors
TOOLS REQUIRED:
Bubble Level
PUMP INFORMATION:
PK120-LV - 120 GPH Low Voltage Pump
6 FT cord length
All of our cast stone is proudly
Revised February 8, 2019

Advertisement

loading

Summary of Contents for Campania International Mini Element with Zen Frog Fountain FT-253

  • Page 1 FT-253 Mini Element with Zen Frog Fountain Pump Kit Parts List PK120-LV pump with transformer (1) Approx. 6” length of 1/2” black non-kink tubing (1) Aluminum spiller/insert (1) Hose clamps (3) * Adhesive Dots (4) * Hose clamps may be used as flow restrictors TOOLS REQUIRED: FOUNTAIN INFORMATION: Bubble Level...
  • Page 2 FT-253 Mini Element with Zen Frog Fountain Assemble your fountain on a level surface capable of holding a minimum of 30 pounds with an approximate 1/2 square foot footprint. 1. Place the adhesive dots on the bottom of the basin to protect furniture surface that fountain is to be placed on.