Setting Up The Internet Bwa System 3200 - Nortel Internet BWA System 3200 User Manual

Procedure 6-4

Setting up the Internet BWA System 3200

Use this procedure to set up and align the Internet BWA System 3200.
On start-up, the Internet BWA System 3200 loads its operating software from
its flash memory. During initialization, the radio remains mute until it
completes its self-diagnostic tests.
After start-up, you can monitor and control the Internet BWA System 3200
with the use of the hand-held terminal (HHT).
Requirements
Required equipment:
•
•
Action
Step
1
Initialize the HHT
2
3
Enter the near-end terminal address
4
5
6
RG-58 coaxial cable or HHT-to-ODU whip antennas
HHT
Action
Apply DC power to the radio.
Stand within 75 meters of the Internet BWA System 3200
Press and hold the ENTER key of the HHT until the display lights up.
The HHT default display appears and reads:
Enter ODU Addr:
Use the keypad to enter the Internet BWA System 3200 address (the ODU
serial number).
Press the ENTER key.
The HHT displays the message:
Establishing Link
When you establish communication between the HHT and the Internet BWA
System 3200, the Near Radio menu appears on the display.
If
you cannot establish communication between
the HHT and the Internet BWA System 3200
otherwise
Installation and commissioning procedures 6-17
—continued—
User guide NTXXXXXX Rel 3.0 Draft October 2000
Then
go to step 7
go to step 8