Parameters For The Near Radio Menu; Control Submenu - Nortel Internet BWA System 3200 User Manual

Parameters for the Near Radio menu

This section describes the parameters within the submenus of the "Near
Radio" menu item

Control submenu

This section lists the parameters within the "Control" submenu of the "Near
Radio" menu. The "Control" submenu allows you to change to the parameters.
Tx Freq
To enter a value to set the transmit RF frequency (in MHz).
Values:
Rx Freq
To enter a value to set the receive RF frequency (in MHz).
Values:
Tx Power
To enter a value to set the transmit power level in dBm.
Values:
FAW
To enter a value to select one of eight possible frame alignment words (FAW)
in the radio frame. This is also used as the Link ID. Both near end and far end
radios must have the same FAW. The Internet BWA System 3200 only
processes a frame that contains the correct FAW.
Values:
Capacity
To enter a value to set the number of tributaries that the radio can multiplex into
the main channel. See also the
Values:
Cbl Lngth
To enter a value to indicate the length of the cable in meters. This parameter
applies for DS1 systems only.
Values:
see Chapter 3, "Technical specifications"
see Chapter 3, "Technical specifications"
18 to XX dBm (15/18/23 GHz) Recommended: 20 dBm
17 to XX dBm (24/26 GHz) Recommended: 20 dBm
16 to XX dBm (28 GHz) Recommended: 20 dBm
16 to XX dBm (31/38 GHz)Recommended: 20 dBm
0 to 7
"Tribut Enab"
2: include tributaries 1 and 2
4: include all tributaries (tributaries 1 to 4)
0 to 40, 41 to 80, 81 to 121, 122 to 162, 163 to 200
User guide NTXXXXXX Rel 3.0 Draft October 2000
User interface description 5-5
for channel centers
for channel centers
parameter for this submenu.