A 100 Vac Input Power Option 100; General Information; Description; Scope Of Appendix A - Agilent Technologies 6010A User Manual

100 VAC Input Power Option 100

General Information

Description

Option 100 is a modification of the power supply that involves changing the values of resistors located in the Overvoltage
Protection and Power Limit Circuits. It also entails recalibrating the unit and changing the Front Panel. These changes allow
the unit to operate at a lower line voltage of 90-105 Vac, while operating on the same line frequency of 48-63 Hz. The
reduced input voltage limits the output power, while retaining the standard unit's output current rating. Other parameters
that change due to Option 100 include the Overvoltage Trip Range and the Remote Analog Programming Specification.

Scope of Appendix A

This appendix contains all the information necessary to support the power supply when it is equipped with Option 100. The
appendix describes only the changes pertaining to Option 100 and how they affect the other portions of this manual. Unless
otherwise specified in Appendix A, all other portions of the manual apply to both the standard supply and Option 100
supply.

Using Appendix A

The Option 100 changes are listed sequentially, starting with Section 1 in the main body of the manual and working back
through Section 3. It is recommended that the user mark all the necessary changes directly into the manual using Appendix
A as a guide. This will update the manual for Option 100 and eliminate the need for constant referrals back to Appendix A.

Section 1 Manual Changes

In Section 1 change the following values in Figure 1-1.
Agilent Model 6010A
VP 170
l
IP 4.7
1
VP 90
2
IP 10.8
2
VP 42
3
IP 17
3

Section 2 Manual Changes

For Agilent Models 6010A, 6011A, 6012B and 6015A: On page 23 under "AC line Impedance Check", where the
maximum output voltages are tabulated, change the voltages as shown below:
6010A change 65 V to 50 V
6011A change 8 V to 6 V
6012B change 22 V to 13.5 V
6015A change 220 V to 150 V
Figure 1-1. Output Characteristic Curve
6011A 6012B
20 50
35 16
12 35
73 26
5.2 13.5
120 50
6015A 6023A
425 17
1.38 10
225 11.1
3.20 18
150 5
5.0 30
A
6028A
50
3.7
35
5.7
15
10
Appendix A 43