Maintenance And Cleansing Precautions; Trouble Shooting - Kohler NUMI 2.0 Homeowner's Manual

Intelligent toilet
Table of Contents

Advertisement

Maintenance and cleansing precautions

Note: for best effect, keep the following in mind when maintaining your Kohler product:
□ Always test your cleaning solution on an inconspicuous area before applying to the entire surface. Wipe
surfaces clean and rinse completely with water immediately.
□ After applying cleaner, rinse and dry any cleanser and dirt sprayed on the surface.
□ Do not allow cleaners to soak on surfaces.
□ Do not use decontamination powder, grinding powders, corrosive detergents such as oil, acid and alkaline
to wipe the remote control.
□ Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring pad to
clean surfaces.
□ No instructions are provided for people who has physical, sensitivity or mental disability, including children,
as well as persons who lack of experience and knowledge.
□ In case the power cord is damaged; to avoid danger, product should be replaced by the manufacturer or the
professionals from its maintenance department or similar departments.
□ Open cover or add water inside the toilet might avoid the plastic parts yellowing problem caused by backflow
air from discharge pipe after residual toilet water evaporated during long-term idle status.
□ Clean surface with neutral soap water, then wipe entire surface with clean soft rag. Many detergents such
as ammonia water, decontamination powder and detergent etc. will cause surface damage. Do not use.
For detailed cleaning information and products to consider, visit www.kohler.com/clean. To order Care & Cleaning
information, call 800-820-2628, 400-820-2628.

Trouble shooting

Note: When the remote control is not in use, it will enter standby mode. Press any key on the remote control
screen to activate the screen.
Aactivate
□ When the toilet is first installed or the power fails, when power is restored or turned on the toilet will automat-
ically go into start-up mode.
□ If the toilet does not function correctly upon completing the start-up sequence, or it fails to start, contact the
Customer Care Center for further service.
Blockage
□ To clear the toilet when there is a blockage, a standard plunger with an insert works best.
Children
□ The automatic flush and cleansing features are activated by a sensor located under the seat. Small children may
not be tall enough (taller than 122cm) to be detected by the sensor. Smart flush and auto flush function will not
operate properly.
1392138-T01-B
16
Kohler Co.

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents