Operation - Hitachi PC-ARFP1E Installation And Operation Manual

OPERATION

12.3 SWING LOUVER DIRECTION
1 Press " " (run/stop). Make sure that the operation is
started. Press " " or " " and select "LOUV".
OK
?
N O T E
For the indoor unit without the auto louver mechanism, the indication of
"LOUV." will NOT be displayed on LCD.
2 By pressing " " or " ", the louver direction will be changed
as follows.
LCD Indication COOL, DRY HEAT, FAN
13 OPERATION
13.1 OPERATION START
Press " " (run/stop). The run indicator will be turned on and the
operation will be started.
OK
22 PMML0404A rev.1.1 - 06/2022
Meeting Room
A/C
MODE SPEED LOUV. TEMP
COOL
MED
SPEED TEMP ADJ
Auto-swing
Recommended
angle
Angle range
Angle range
Recommended
angle
Meeting Room
A/C
MODE SPEED LOUV. TEMP
COOL
MED
MODE LOUV. ADJ
: Auto swing operation will be started. At this time, the
louver will swing repeatedly on LCD.
OK
?
N O T E
• The air flow angle is different for each indoor unit type. Check
Installation & Operation Manual for Indoor Unit to be used for the
detailed information.
• Louver position on LCD and the actual louver position may not match
during the auto swing operation. To fix the louver positions, set the
angle after checking the position on LCD.
• The louver may NOT stop immediately right after the switch is
pressed.
?
N O T E
• Temperature/Air Flow Setting
• The setting condition will be memorized once after the setting is
confirmed, therefore the daily setting is not required. In case that the
setting change is required, refer to the
Setting Method" chapters.
Meeting Room
A/C
MODE SPEED LOUV. TEMP
COOL
MED
SPEED TEMP ADJ
"11 Operation Method" and "12