Samsung DA99-02318T-00 User Manual page 21

COUPLER "A"
LINE OUTLET
SIDE OF
PURIFIER
PURIFIER WATER
COUPLER
WATER INLET
SIDE OF PURIFIER
Replacement Instructions
1. Shut off water supply.
2. Note the Flow direction on the fi lter.
3. Insert water supply tube into the inlet side of the
fi lter until the tube stop.
FLOW DIRECTION
WATER SUPPLY
INLET SIDE
4. After inserting tube, put together the clip strongly.
The Clip fi x the tube.
5. Turn on the water and check for leaks. If leaks
occur, repeat step 1,2,3,4. If leaks persist,
discontinue use and call your supporting dealer.
6. Flush fi lter for 5 minutes before use.
DA99-02318T-00.indb 21 DA99-02318T-00.indb 21
TAP
90 degree
CAUTION
Insert Locking Clip After Insert Locking Clip After
tube seated tube seated
Locking Clip Locking Clip
PERMEAT
Note :
You must also ensure
that the cut is square
and not at any sort
of angle as this could
cause a leak
Remove any residual matter inside the
purifi er. (Model with the purifi er)
- Open the main water tap to check whether water
is running through the water tube on the water inlet
side of the purifi er.
- If water does not come out through the line, check
whether the tap is open.
- Leave the tap open until clean water is running
out and any residual matter that built up during
manufacturing has been removed.
OUTLET SIDE
OF PURIFIER
WATER
Attach the purifi er lock-clip.
- Hold the purifi er lock-clip in the appropriate position
(under the sink for example) and fi x it tightly into
place where to screw.
PURIFIER LOCK-CLIP
Secure the purifi er in position.
- Fix the purifi er in position, as shown in the fi gure on
the right.
WATER TUBE
PURIFIER LOCK-CLIP
PURIFIER
WATER LINE
PURIFIER
_21
setting up
14. 6. 10. 14. 6. 10. 8:25 8:25