Table of Contents
Advertisement
electrical charges sufficient to damage ES devices.
6. Do not remove a replacement ES device from its protective
package until immediately before you are ready to install it. (Most
replacement ES devices are packaged with leads electrically
shorted together by conductive foam, alminum foil or
comparableconductive material).
7. Immediately before removing the protective material from the
leads of a replacement ES device, touch the protective material to
the chassis or circuit assembly into which the device will be
installed.
Caution
Be sure no power is applied to the chassis or circuit, and observe
all other safety precautions.
8. Minimize bodily motions when handling unpackaged replacement
ES devices. (Otherwise hamless motion such as the brushing
together of your clothes fabric or the lifting of your foot from a
carpeted floor can generate static electricity (ESD) sufficient
todamage an ES device).
3. Self Check
1. Self-Check is used to automatically check the bus lines and
hexadecimal code of the TV set.
2. To get into the Self -Check mode press the Down (
the customer controls at the front of the set, at the same time
pressing the Recall button on the remote control, andthe screen
will show :
5
) button on
Advertisement
Table of Contents
