Restore Factory Settings - Xiaomi Mi Bedside Lamp 2 User Manual

Restore Factory Settings

Simultaneously press and hold the power button and mode button for 5 seconds, until the lamp starts
circulating through the colors red, green and blue, then release the buttons. After the circulating colors
end, the lamp will automatically restart, and restoring factory settings will be completed.
* When using the bedside lamp in a new network environment, you need to restore factory settings
and connect to the network again.
Precautions
• Make sure the voltage is consistent with the product's working voltage before use. Using the
incorrect voltage may damage the product and cause a potential safety hazard.
• The light source contained in this luminaire shall only be replaced by the manufacturer or his service
agent or a similar qualified person.
• The lamp will produce heat during operation, please use it in a well-ventilated area so that heat can
dissipate.
• Do not use non-standard adapters to avoid product damage or safety hazards.
• Place the lamp steadily and do not tip it over during use.
• Under normal use of condition, this equipment should by kept a separation distance of at least
20 cm between the antenna and the body of the user.