Advertisement
STEP 1
• Start building the set by locating and
attaching one stacking bridge to one
baseplate.
• Next, attach one end of a loop to
the built-in track joiner on the stacking
bridge , as shown to the right. Attach the other
end of the loop to the built-in track joiner in
front of the stacking bridge on the baseplate.
• Attach another loop by placing one end in
the unused half of the built-in track joiner on
the baseplate, as shown to the right. Attach
the other half to the built-in track joiner to the
left of the stacking bridge, at a 90° angle.
• Next, attach a flexi-curve to the built-in
track joiners on either side of the baseplate,
as shown.
• To complete the step, add a 14" Straight
track to the unused half of the stacking
bridge.
• Put this configuration to the side for now.
STEP 2
• Attach 1 large joiner to 1 bar by sliding the bar
through the short channel on the underside of the
large joiner. See Figure 2.1.
• Locate 2 more bars, 2 couplers, and 4 more large joiners.
• Attach 2 large joiners to each of the 2 bars, but this time slide the bars through the long channel on the
underside of the large joiners.
• Connect all 3 bars from this step, using the couplers as shown in Figure 2.2.
• Attach 2 stacking bridges to the large joiners on the left side and 2 on the right. Leave the large joiner in the
middle empty for now.
Stacking
Bridges
Bar
The bar goes through the
LONG CHANNELS of these 2
Large Joiners.
Attached on
Built-in Track
Joiner
Built-in
Track Joiner
Straight Track
The bar goes through the
SHORT CHANNEL on the
uderside of this Large Joiner
Bar
Couplers
The bar goes through the
LONG CHANNELS of these
2 Large Joiners.
PAGE 3
FIGURE 1
First
Loop
Second
Loop
Stacking
Bridge
Large Baseplate
FIGURE 2.1
Underside View
short
channel
FIGURE 2.2
Stacking
Bridges
Underside View
long channel
Bar
Flexi-Curve
Built in
Track Joiner
Advertisement
