Advertisement
Available languages
Available languages
EN
Sketch V
Wall Corner & Edge Working Sketch
Step 5 Please look at Sketch V, they are instructions to tell
you how a support frame supports the grinder with wall cor-
ner&edge working.
EN
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of the
products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be included
in the product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or
for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by tech-
nicians of the authorized service department of the manufacturer.
6
For your safety, please read this manual carefully
before using, and keep it properly for future reference.
WWW.BORMANNTOOLS.COM
1
1. Loosen the torx screw and adjust the distance between the
wheel and the wall, then tighten the screw again.
2
2. According to the direction shown, drive the machine stably for
wall corner & edge working (please assure that the wheel gets
close to the wall at the same time)
Advertisement
