Silo Operation; Filling A Mortar Tub; Mortar Consistency - CPI EuroMix Silo Operating Instructions Manual

SILO OPERATION

silO OPEraTiON

FILLING A MORTAR TUB

filliNg a MOrTar Tub
The mixer operates on a timer. This timer will be adjusted during
The mixer operates on a timer. This timer will be adjusted during
the set-up of your CPI EuroMix silo to suit the size of your the set-up of your CPI EuroMix silo to suit the size of your
mortar tubs. mortar tubs.
The timer cannot be adjusted whilst the mixer is running and The timer cannot be adjusted whilst the mixer is running and
should only be adjusted by a qualified person.
should only be adjusted by a qualified person.
1
Turn the isolator to
the on position

MORTAR CONSISTENCY

MOrTar CONsisTENCy
Adjust the mortar to the required consistency by slowly turning Adjust the mortar to the required consistency by slowly turning
the black water tap. This can be found on the left hand side of the black water tap. This can be found on the left hand side of
the combined panel, or inside the water panel on a split unit. the combined panel, or inside the water panel on a split unit.
This adjustment will be carried out by the CPI EuroMix Service
Always start the mixer with the product handle on the silo in the
Always start the mixer with the product handle on the silo in the
shut position (horizontal). shut position (horizontal).
When the mixer is running and water can be seen coming from When the mixer is running and water can be seen coming from
the mixer outlet, slowly open the product handle (move towards the mixer outlet, slowly open the product handle (move towards
the vertical).
the vertical).
2
Press the on switch
Technician during the set-up process, but can be altered by the This adjustment will be carried out by the CPI EuroMix Service
user. Technician during the set-up process, but can be altered by the
user.
Be careful not to run the material too dry, as this could cause
Be careful not to run the material too dry, as this could cause
the mixer to stall and the motor to trip the protection device.
the mixer to stall and the motor to trip the protection device.
Open
3
Once water can be seen coming from
the mixer outlet, move the product
handle to the vertical (open) position
Close
9 9