Table of Contents
Advertisement
ISAN10 & ISRL10 User Manual
4 INSTALLATION
The Anchor and Relay devices have been designed to be clipped into a wall / ceiling mount. Do not
obstruct the front face of the device and always have it facing outwards to achieve optimal
performance. The system works best when there is an unobstructed view of the mobile device but will
still work well if the sound can travel around those objects. Objects closer to the unit will have a more
significant impact on performance. As a rule of thumb, it is best to have at least 10 (3 meters) feet of
unobstructed view from the device.
4.1 INSTALLING THE MOUNT
Once the site layout has been created and the location for each Anchor and Relay node chosen, (See
"Safe Space Site Design Considerations"), the mount can be installed to almost any wall or ceiling
surface either using two self-tapping screws or by welding the mount in place.
4.2 INSTALLING THE DEVICE
The Anchor or Relay unit can be clipped into the mount by inserting one tab in the lower mounting arm
and then pushing the unit into the upper mounting arm. There are three tabs at either end of the unit
allowing the device to be angled to a better position to cover the area.
4.3 SECURING THE DEVICE TO THE MOUNT
Once the Anchor or Relay unit is installed in the proper orientation in the mount the two mount
securing screws can be tightened to ensure the mounting tabs cannot accidentally come out of the
mount. A cable connected the device can now be secured to the mount to stop the device from falling
should it be dislodged from the mount.
2021-01-29
9
Advertisement
Table of Contents
