Service Function Table - Panasonic KX-FM89BX Service Manual

(1) (2) RESULT
CODE
51 COMMUNICATION
ERROR
52 NO RESPONSE
54 ERROR-NOT YOUR
UNIT
58 COMMUNICATION
ERROR
59 ERROR-NOT YOUR
UNIT
64 COMMUNICATION
ERROR
65 COMMUNICATION
ERROR
65 COMMUNICATION
ERROR
68 COMMUNICATION
ERROR
70 ERROR-NOT YOUR
UNIT
72 COMMUNICATION
ERROR
75 MEMORY FULL
79 CANCELED
FF COMMUNICATION
ERROR
SND=TRANSMISSION RCV=RECEPTION
Most fax communication problems can be resolved by the following steps.
1. Change the transmit level. (Service code: 596, refer to
FUNCTION TABLE().)
2. Change the TX speed/RX speed. (Service code: 717/718, refer to

SERVICE FUNCTION TABLE

Note*:
If the problem remains, see the following "Countermeasure" flow chart.
(3) MODE
RCV PIN is transmitted.
RCV Reception is finished when the T1 TIMER expires.
RCV DCN is received after DIS transmission.
RCV DCN is received after FTT transmission.
SND DCN responds to the post message.
SND Polling is not possible.
SND DCN is received before DIS reception.
RCV Reception is not EOP, EOM PIP, PIN, RTP or RTN.
RCV No response at the other party after MCF or CFR is
transmitted.
RCV DCN is received after CFR transmission.
RCV Carrier is cut when the image signal is received.
RCV The document was not received due to memory
full.
SND The multi-station transmission was rejected by the
user.
SND &
Modem error. For the DCN, DCN, etc.
RCV
abbreviations, refer to
().)
72
SYMPTOM
MODEM SECTION
SERVICE
Counter
measure
().