Installation - Qlightec QWTD Series Quick Start Manual

Replacing/ Rearranging LED Lens Units

Installation

• The user need to install the mounting bracket on to the mounting surface first to fix the product body on to the mounting surface.
• Drill proper mounting holes in accordance with the number of LED lens unit, referring to the installation diagrams below.
6-Ø4 HOLES
Ø13 CABLE
ENTRY
4-Ø4 HOLES
Ø13 CABLE
ENTRY
2-Ø4 HOLES
Ø13 CABLE
ENTRY
Installation Environment and Protection Rating
• This product is designed for indoor use with protection rating of IP54.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating
indicated(IP54), it may cause malfunction or damage to the product.
• For further information, please visit our website(www.qlight.com).
①
②
③
④
5-Ø4 HOLES
Ø13 CABLE
ENTRY
3-Ø4 HOLES
Ø13 CABLE
ENTRY
Please ensure the power is off before replacing or rearranging the
LED units. Please carefully follow the following instructions.
1. Remove the head cover ② by loosening the fixing screw ① .
2. Remove the LED unit by pulling it ③ upward.
3. Replace or rearrange the LED units.
4. Assemble in the reverse order of removing the LED units, Be careful
not to let the rubber packing ④ fitted on the top of each unit come off.
①
M4-25 BOLT
③
Remove the mounting bracket from the product by removing
①
two M4 screws from the speaker unit.
Mount the mounting bracket to the mounting surface.
②
Hook the rear of the head cover to the upper bracket, then
③
push the body against the mounting bracket.
After tightly attaching the product body to the mounting
④
bracket, tighten the two M4 screws removed in step
bottom of the speaker unit.
5
②
④
M4-25 BOLT
at the
①