Table of Contents
Advertisement
Mounting Hole Specifications
• Machine holes on the mounting surface referring to
the diagram below.
4-Ø9 HOLES
Bulb/ Xenon Bulb Replacement Instructions
■ Bulb Replacement Instructions(SESA only)
Assemble bulb
• Please wait at least 1 minute after turning off the power
before replacing the bulb.
• In order to dissemble the bulb, please push down the bulb( ① )
lightly and screw it counterclockwise.
• In order to put the bulb in to the unit, please place the bulb( ① )
in the socket( ② ) and screw it clockwise while lightly pushing
down the bulb.
Precautions for installation
• In case of outdoor applications, install the product in the upright
position. Do not install the product horizontal or upside-down
positions where water can potentially penetrate into the product
and impact it's operation.
Installation Environment and Protection Rating
• This product is designed to be explosion proof.
• Please make sure to use the product in an environment that meets the specified explosion proof rating and regulations.
• For further information, please visit our website (www.qlight.com).
①
②
Disassemble bulb
Grounding Instructions
Please use an M4 bolt at the location marked in the diagram
•
above to ground the product.
•
When connecting the grounding cable, please use a ring terminal.
• Please use a grounding cable with a diameter greater than 4mm.
■ Xenon Bulb Replacement Instructions(SESAS only)
Disassemble bulb
• Please wait at least 30 minutes after turning off the power before
replacing the xenon bulb.
• Please pull out the entire xenon bulb structure ① to disassemble
while pushing the hook down.
• For xenon bulb assembly, please push down the connector
portion of the xenon bulb structure to the connector pin
location ② until it makes "clark" sound.
Left direction
Reverse direction
5
M4 ground contact part
①
Assemble bulb
②
Right direction
WALL
[Installation]
Advertisement
Table of Contents
