Specifications; Power Supply - Makita LS1030N Instruction Manual

ENGLISH
1 Bolt
2 Center cover
3 Socket wrench
4 Shaft lock
5 Loosen
6 Arrow
7 Blade case
8 Saw blade
9 Spindle
10 Flange
11 Ring
12 Hex bolt
13 Tighten
14 Safety cover
15 Dust spout
16 Dust bag
17 Fastener

SPECIFICATIONS

Model
Blade diameter ....................................................................................................................................255 mm - 260 mm
Hole (arbor) diameter
For all countries other than European countries ........................................................................... 25.4 mm and 25 mm
For European countries ...................................................................................................................................... 30 mm
Max. cutting capacities (H x W) with blade 260 mm in diameter
Bevel angle
0°
No load speed (min ) .............................................................................................................................................. 4,600
-1
Dimensions (L x W x H) ......................................................................................................530 mm x 476 mm x 532 mm
Net weight.................................................................................................................................................................11 kg
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Note: S pecifications may differ from country to country.

Power supply

The tool should be connected only to a power supply
of the same voltage as indicated on the nameplate,
and can only be operated on single-phase AC
supply. They are double-insulated in accordance with
European Standard and can, therefore, also be used
from sockets without earth wire.
Symbols
The followings show the symbols used for the tool. Be
sure that you understand their meaning before use.
q Read instruction manual.
q DOUBLE INSULATION
6
Explanation of general view
18 Lock-off button
19 Switch lever
20 Lever
21 Kerf board
22 Turn base
23 Adjusting bolt
24 Pointer
25 Miter scale
26 Latch spring
27 Grip
28 Vise rod
29 Screw
30 Guide fence
31 Clamp screw
32 Vise arm
33 Support
34 Knob
Miter angle
90.5 mm x 95 mm
69 mm x 135 mm
35 Projection
36 Holder
37 Holder assembly
38 Rod 12
39 Cutting line
40 Groove
41 Vise
42 Spacer block
43 Aluminum extrusion
44 Over 10 mm
45 Over 460 mm
46 Hole
47 Set plate
48 Triangular rule
49 Limit mark
50 Screwdriver
51 Brush holder cap
0°
q T o avoid injury from flying debris,
q For your safety, remove the chips,
45° (left and right)
90.5 mm x 67 mm
69 mm x 95 mm
keep holding the saw head down,
after making cuts, until the blade
has come to a complete stop.
small pieces, etc. from the table top
before operation.
LS1030N