FireplaceXtrordinair ProBuilder 42 CF Manual

Compatibility

ProBuilder 42 CF (MV, GSB2, GSR2) Fireplace.
Installation Warnings
NOTE: Consult the installation manual for the order of installation. If using propane (LP), convert the
appliance before installing the log set. If using firebacks, install them prior to installing the log set.

The logs are fragile, especially after being exposed to heat.

Make sure the gas control valve is OFF and the heater is cool prior to conducting service.

Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.

The burner must be correctly positioned before installing the log set. Make sure the burner is fully seated
and the pilot is properly aligned. See owner's manual for details on burner removal.
Log Set Overview
When installed, the (10) logs should appear as shown below.
Log #5
Log #6
Installation
The installation of this log set should only be done AFTER the unit has been converted to LP Gas (if applicable)
and after the installation of the embers, and Rockwool (MV, GSB2, and GSR2) and the Ember-Glo™ glass
(GSR2 ONLY). See the information on the following (2) pages for details on preparing the burner.
Page 1 of 10
PB42 CF BonFyre
(sku# 94500772)
Log #2
Log #3
Log #8
17602206 — 5/3/21
Log #1
Log #7
Log #10
© Travis Industries, Inc.
Log #9
Log #4