JUMP LEADS KH4217
Intended use
These battery jumper leads are intended exclusively for private use and for
utilisation in the brief bridging of a flat standard commercial starter battery
(lead battery for vehicles) with a power source of 12 V - 24 V. These battery
jumper leads may ONLY be used for supplying power to petrol motors
with a cylinder capacity of up to 2500 cm
diesel motors!).
Technical data
Cable length:
max. Cylinder capacity:
Safety information
• Before starting the bridging procedure, be sure to check the details given
in the operating handbooks for BOTH vehicles.
• Check to ensure that the two batteries have the same rated voltage (e. g.
12 Volt). The capacity (details in Ah) of the supplier battery should not
be significantly smaller than that of the receiver battery.
• Ensure that the permitted cylinder capacity limits of the battery jumper
leads are not being exceeded by the vehicles.
• There may NOT be any bodywork contact existent or possible between
the two vehicles.
3 m
2500 cm
(they are NOT suitable for
3
Cross-section:
Petrol motor / NO diesel motors!
3
- 2 -
16 mm
2