Table of Contents
Advertisement
(For EB)
2.4.1 Information for Your Safety
IMPORTANT
Your attention is drawn to the fact that recording of pre-recorded tapes or discs or other published or broadcast material may infringe copyright
laws.
WARNING
To reduce the risk of fre or shock hazard, do not expose this equipment to rain or moisture.
CAUTION
To reduce the risk of fre or shock hazard and annoying interference, use the recommended accessories only.
FOR YOUR SAFETY
DO NOT REMOVE THE OUTER COVER
To prevent electric shock, do not remove the cover. No user serviceable parts inside. Refer servicing to qualifed service personnel.
2.4.2 Caution for AC Mains Lead
For your safety, please read the following text carefully.
This appliance is supplied with a moulded three-pin mains plug for your safety and convenience.
A 5-ampere fuse is ftted in this plug.
Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 5 amperes and it is approved by ASTA or BSI to
BS1362
Check for the ASTA mark or the BSI mark on the body of the fuse.
If the plug contains a removable fuse cover you must ensure that it is reftted when the fuse is replaced.
If you lose the fuse cover, the plug must not be used until a replacement cover is obtained.
A replacement fuse cover can be purchased from your local Panasonic Dealer.
If the ftted moulded plug is unsuitable for the socket outlet in your home then the fuse should be removed and the plug cut off and disposed of
safety.
There is a danger of severe electrical shock if the cut off plug is inserted into any 13-ampere socket.
If a new plug is to be ftted please observe the wiring code as shown below.
If in any doubt, please consult a qualifed electrician.
2.4.2.1 Important
The wires in this mains lead are coloured in accordance with the following code:
Blue Neutral
Brown Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal in the plug which is marked with the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the letter L or coloured RED.
Under no circumstances should either of these wires be connected to the earth terminal of the three pin plug, marked with the letter E or the
Earth Symbol.
file:///C|/U...Temp/Rar$EXa0.654/viewing/SGML_VIEW_DATA/ALL/DMC-FZ1000P/SVC/DSC1407014CE/doc/DSC1407014CE_02.xml[11/12/2018 5:11:17 PM]
Advertisement
Table of Contents
