Advertisement
Quick Links
ACCESSORY SETUP INSTRUCTION
HEATED DRIVER SEAT ASSY-- PN 5HY0-805100-1000
VALID FOR: MY2019 and Newer UFORCE 1000 UTVs
BEFORE YOU BEGIN: Read and understand the instructions before starting any work. Make sure that all parts are
ready and that you have all the tools required for assembly.
NOTE: CFMOTO shall not be liable for any damage caused by incorrect assembly. CFMOTO recommends that all
original accessories be assembled by an authorized CFMOTO dealer.
Before assembly, park the vehicle on a flat surface, put the transmission gear into Park (P) and turn off the key switch.
Zhejiang CFMOTO Power Co., Ltd.
permitted only with the express written permission of the copyright owner.
MEANING OF SYMBOLS
i
- Indicates information with more details or tips.
!
- Indicates information of warning or danger.
PARTS LIST:
ITEM
PART NAME
1
HEATED DRIVER SEAT ASSY
2
HEATED DRIVER SEAT
3
BRACKET, HEATING SWITCH
4
SEAT HEATING SWITCH
5
SELF-TAPPING SCREW ST4.8×13
6
TOOL LIST:
ITEM
1
2
3
All rights reserved. Reproduction of this document, even in part, as well as copying of all kinds, is
TIE BAND
DESCRIPTION
13mm ALLEN WRENCH
PROTECTIVE GLOVES
CUTTER
PART NUMBER
5HY0-805100-1000
5HY0-131200-20000
5HY0-130001
5HY0-136000
30110-480130010
8010-150003
QTY.
REMARK
1
1
Recommended tools
1
QTY.
REMARK
1
1
1
The image below is not
the final product.
1
3
1
Advertisement
Summary of Contents for CF MOTO 5HY0-805100-1000
- Page 1 ACCESSORY SETUP INSTRUCTION HEATED DRIVER SEAT ASSY-- PN 5HY0-805100-1000 VALID FOR: MY2019 and Newer UFORCE 1000 UTVs BEFORE YOU BEGIN: Read and understand the instructions before starting any work. Make sure that all parts are ready and that you have all the tools required for assembly.
- Page 2 ASSEMBLY and INSTALLATION ∥ Remove the driver seat assy (A). ∥ Place the driver seat assy (A) on a protected stable work surface and remove the bolts (B) shown. ∥ Turn the handle (C) to adjust the seat base position, creating access for removal of the remaining upper bolts (B).
- Page 3 ASSEMBLY and INSTALLATION ∥ Remove the seat left lower guard (D) ∥ At the front of the lower deco panel, use a cutting tool to remove the cut-out (E) as shown under the seat. Use extreme caution to prevent damage to the surrounding plastic.
- Page 4 ASSEMBLY and INSTALLATION ∥ Connect port (F) to port (G) of the seat heating switch. ∥ Connect the seat switch port (H) to the seat heating port (I), and secure them with tie band (6) as shown. ∥ Position the heated driver seat cable (J) as shown in the image and install the seat left lower guard (D).