Advertisement
Quick Links
www.sylvania.com/Signage
BoxLED
BX-DS-PL
Signage Lighting System
INSTALLATION GUIDE
WARNING: ONLY QUALIFIED PERSONNEL SHOULD PERFORM INSTALLATION
TO AVOID ELECTRICAL SHOCK OR COMPONENT DAMAGE, DISCONNECT POWER BEFORE
PERFORMING INSTALLATION OF THE POWER SUPPLIES, MODULES, AND/OR RGB CONTROLLERS.
Failure to install the power supplies and/or LED modules in accordance with the National Electric Code (NEC), all
applicable Federal, State, and local electric codes as well as the specific Underwriters Laboratories (UL) safety
standards for the installation, location and application may cause serious personal injury, death, property damage
and/or product malfunction.
These instructions are guidelines for installation of LED modules and power supplies. Installation requirements may
vary depending on the application. Licensed electricians should provide all installation services for connection for
both primary and secondary (input/output) of the power supplies.
1.0 PREPARE FOR INSTALLATION
1.1 Tools Required:
-
Wire stripper/cutter
-
Screwdriver
-
Measuring tape
1.2 Supplies Required:
-
PLTC cable
-
Wire nuts/connectors
-
#8 screws or rivets
-
Accessory Mounting Track and Brackets
1.3 Carefully remove existing neon or fluorescent tubes, HID or incandescent light sources and power
supplies and/or ballasts if necessary.
Make sure power is turned off.
1.3.1
Where applicable, determine if a disconnect switch needs to be installed (may be
a.
integral with existing power supply/transformer).
Remove all existing screws, sockets and wiring.
1.3.2
Dispose of all old sign components in the proper manner.
1.3.3
Repair and seal any unused openings in the sign enclosure. Openings greater than ½"
1.3.4
diameter require a metal patch secured by screws or rivets and caulked with non-
hardening caulk. Smaller openings may be sealed with non-hardening caulk.
Clean the inside of the sign to make sure it is free of dirt.
1.3.5
LED446
®
DS Plus (Double Side)
RETROFIT SIGN CONVERSION LED KIT
FOR USE ONLY IN ACCORDANCE WITH KIT INSTRUCTIONS
E311887 3SNE
Advertisement
Related Manuals for Sylvania BoxLED DS Plus
Summary of Contents for Sylvania BoxLED DS Plus
- Page 1 ® BoxLED DS Plus (Double Side) BX-DS-PL Signage Lighting System INSTALLATION GUIDE WARNING: ONLY QUALIFIED PERSONNEL SHOULD PERFORM INSTALLATION TO AVOID ELECTRICAL SHOCK OR COMPONENT DAMAGE, DISCONNECT POWER BEFORE PERFORMING INSTALLATION OF THE POWER SUPPLIES, MODULES, AND/OR RGB CONTROLLERS.
-
Page 2: Mechanical Instructions
MECHANICAL INSTRUCTIONS 2.1 Refer to desired module layout 2.2 Measure inside cabinet dimensions 2.3 Required track lengths... - Page 3 2.4 Cut the two “b” track segments to length – be certain the dimension “d” on both track pieces is the same to ensure the tracks are parallel in the case 2.5 Attach the two “b” track segments to the sides of the case...
- Page 4 2.6 Examples of module spacing...
- Page 5 2.7a Insert BoxLED Plus DS modules into the required number of “a” track pieces – referring to step 2.6 for layout options 2.7b Insert one end of the module into the track and push down on the opposite end until it clicks into place 2.8 Loop any excess wire around the track in-between the modules and tie wrap it into place...
- Page 6 2.9 Slide the Left and Right mounting brackets onto the corresponding ends of each of the “a” track segments 2.10 Slide the assembly into the desired mounting holes in the “b” track segments and push down on the left and right brackets so they click into place...
-
Page 7: Electrical Instructions
ELECTRICAL INSTRUCTIONS 3.0 Use wire nuts or connectors to connect the white and red (+) input wire of the modules to the red (+) output wires of the 24V power supply. Connect the black and white (-) input wire of the modules to the blue (-) output wire of the 24V power supply (see Figure 11). -
Page 8: Troubleshooting Guide
Replace the module. Observe correct polarity. not light damaged Specifications subject to change without notice OSRAM, BoxLED, and OPTOTRONIC are registered trademarks of OSRAM GmbH SYLVANIA is a registered trademark of OSRAM SYLVANIA Inc. © 2014 OSRAM SYLVANIA Inc. 09/14...