WilTec HW Series Manual page 15

2. You can then access your filter
trays to be able to clean the filter
media or add filter media. Repeat step
one to refasten the filter head to the
base of the filter.
© by WilTec Wildanger Technik GmbH
http://www.wiltec.info
1. To set your filter up, the buckles (1)
and (2) should be unclipped from the
main body of the filter head this will
then seperate the head from the base
of the filter.
3. Push the inlet and outlet taps into
the filter head and fasten using the
small handle in between the taps this
is also the shut of valve. After this at-
tach your hose to each tap and se-
cure using the screw caps.
Depending on
the model
Seite 3