Advertisement
Contact Us:
Toll Free: 888-794-6250
675 West. 14600 South Bluffdale, UT 84065
www.GOALZERO.com
We proudly support Tifie Humanitarian www.tifie.org
From AC, 12V, or solar panels.
Plug in any AC*, 12V, or USB device.
*AC inverter sold seperately.
To stay prepared keep devices plugged into AC, 12V, or solar panel.
A: Push the white power button below the LCD battery monitor and it will light up.
A:The LED battery monitor displays charge level in 20% increments. If all areas are shaded and the monitor says "FULL", then it is charged up and ready to go.
A: No. Although the SHERPA is durable, electricity and water don't mix well. Make sure the ports are dry before using the device.
A: Yes, the SHERPA is perfect for keeping your devices charged on long flights.
A: It can hold its charge for several months. However, to keep the battery healthy and ready to go, we recommend that you leave your SHERPA 50 plugged in between uses. If this is not possible, charge it every 3-4 months.
A: Lithium-ion NMC. It has these advantages: stores more energy; smaller and lighter watt for watt; and retains its charge even after months of storage.
A: Yes. You can chain multiple Sherpas together through the sidecar port. Contact goalzero.com for the chaining cord.
A: The SHERPA has a built-in feature that turns the unit off after a period of inactivity. This saves power. To override this mode and keep it in "always on" mode, simply hold down the power button for about 10 seconds. A small "ON" icon will appear in the upper left side of the LCD battery monitor if you are in "always on" mode. In this case, it will only turn off if it runs out of power or you turn it off.
Note for Extreme Users:
Long Term Storage: For long-term storage (up to a year), charge the Sherpa 50 to 50% full, then remove the fuse, and store in a cool place.
Usage: | |
Charge every 3-4 months, to maintain battery life. | |
For up to 1-year storage, discharge to 50%, remove fuse, shelve in cool temperature | |
Charging With: | Approximate Charge Times |
AC wall charger | 3 hours |
12V car charger | 3-4 hours |
GOAL ZERO Nomad 13.5 | 6-12 hours |
Inputs | |
Charging port (8.0mm, blue, circle) | 15-25V (30W max) |
Outputs | |
USB Port | 5V, 0-1.5A (7W max), regulated |
12V port (6.0mm, green, hexagon) | 12V, 0-6A (75W max), regulated |
Sidecar port (9mm, side) | 9-13V, 0-10A (75W max), not regulated, Use with Sherpa inverter or for chaining |
Laptop port (7.4mm, orange, square) | 19V, 0-5A (75W max) regulated |
AC Inverter (sold separately) | 110VAC (75W max), modified-sine wave |
Internal | |
Battery type | Lithium-ion (NMC) |
Battery capacity | 50Wh+ (2x3x3.6V, 2.6Ah cells) |
Battery voltage range | 9-13V |
BMS | Built-in charge controller, and cell output protection |
Life-span | hundreds of cycles |
Fuses | 10A, standard car fuse |
General | |
Chainable | yes, with other Sherpa V2 |
Weight | 1.1lbs |
Dimensions | 4.5 x 1.5 x 5 in (11.4 x 3.8 x 12.7 cm) |
Warranty | 12 months |
Tested and Certified | FCC, CE |
Operating usage temp. | 32-104F (0-40C) |
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Need help?
Do you have a question about the Sherpa 50 and is the answer not in the manual?
Questions and answers