Cowin E7 Headphones Manual

Specification

E7

Load impedance: 32Ω
S/N: ≥90dB
Frequency range: 22Hz-20KHz
Power supply: Lithium battery or USB cable
Audio source: iPhone, iPad, Smartphone, Notebook, MP3, MP4, etc
Function spec: Bluetooth, Microphone, Active Noise Cancelling
Size: 166x92x181mm

Operating range up to 20 meters.

Battery Precautions

The device can be powered by a built-in rechargeable lithium battery. Please charge the battery for at least 8 hours before your first use of device.

• If the device is not used for a long period of time, the battery may be out of power. Please charge the battery.
• Rechargeable batteries are only to be charged under adult supervision.
• Use only the supplied micro USB cable to recharge the battery. Improper charging may damage the battery and the device.
• Do not attempt to open the rechargeable battery or battery pack. There are no serviceable parts inside.
• Should a battery leak, the device may become damaged. Clean the battery compartment immediately, avoid touching your skin.
• Keep the battery out of reach of children. If swallowed, consult a physician immediately.
• Avoid storing the battery in extremely hot or cold environment. A device with a hot or cold battery may not work temporarily, even when the battery is fully charged.
• Do not dispose batteries in a fire as they may explode. Batteries may also explode if damaged. Please dispose them according to local regulation. Do not dispose them as household waste.

Getting Started

Installation Operation

1. Put on this headphone
   
2. Adjustable length
   
3. Adjustable angle
   
   It can be adjusted to be fit by twisting the left and right ear muffs
   

Cable Connection

Bluetooth Connection

Pairing headphone to your Smart device (Smart device should be within 10 meters of this headphone).

1. Activate pairing mode on headphone by turn the switch to "BT". The LED will flash in blue.
2. Turn on Bluetooth function of your device, (refer to the device owner's manual to locate Bluetooth function).
3. Select "Search" or "Discover" devices.
4. Select "E7".
5. If requested, type the password or PIN 0000.
6. Press the Enter key.

After completing the steps above, a message on your Smart device will appear confirming that your device is now paired/ connected.

In case of unsuccessful pairing, turn off it and restart, then do as steps above. If the Bluetooth on your smart device remains open, when you restart the headphone, the Bluetooth will be connected automatically.

NFC Connection

NFC: Near Field Communication, is a set of standard for wireless devices to establish radio communication with each other by touching them together or bringing them into close proximity, usually within a few centimeters.

Please activate the NFC function of your smart device and put the device close to the Bluetooth headphone.

Your smart device will ask you if you want to pair with the headphone, choose Yes or OK to complete the pairing process.