Intermec IP4 Instructions Manual

Device Name: RF Identification Serial Radio Module
The responsible party for the compliance of this device is:
This product conforms to the following approvals. The user(s) of this product are cautioned to use accessories and peripherals
approved by Intermec Technologies Corporation. The use of accessories other than those recommended, or changes to this
product that are not approved by Intermec Technologies Corporation, may void the compliance of this product and may result in
the loss of the users authority to operate the equipment.
This device complies with Part 15 of the FCC Rules, and the Industry Canada Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC Digital Emissions Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Reorient or relocate the radio of television receiving antenna.
•
Increase the separation between the computer equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
•
Consult the dealer or an experienced radio television technician for help.
Canadian Digital Apparatus Compliance
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
Warning: per the FCC and Canadian RF (radio frequency) exposure requirements,
1) Antennas must be supplied and installed as recommended by Intermec Technologies Corporation to ensure compliance to RF exposure
requirements. The antennas approved for use are listed in the Intermec accessories guide for the IM4 PC Card. Correct antenna
mounting is fully described within the Intermec IM4 PC Card Users Guide.
2) When installing and using Intermec Technologies Corporation-approved remote antennas associated the RFID reader, a 20-cm (8-inch)
passing distance must be maintained from any body part of the user, or near by persons, and the remote antenna. The antenna must not
be touched during transmitter operation.
3) Cables attached to the remote antennas must have a minimum length as provided from Intermec Technologies Corporation to insure
the proper losses to control RF exposure.
4) RF safety requirements mandate this device cannot be co-located with other transmitters unless such co-location is specifically
approved by the FCC.
5) Integrators of the radio module are obligated to pursue regulatory approval and labeling of this transmitter under FCC Part 2 and Part
15 rules. Industry Canada approval and labeling requirements must be met for marketing of the integrated product in Canada.
Warning: Per Canadian RF exposure requirements,
1) The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF field in excess of
Health Canada limits for the general population; consult Safety Code 6, obtainable from Health Canada's website
www.hc-sc.gc.ca/rpb
578-100-137 Revision A
*578-100-137A*
*578-100-137A*
Compliance Statement Insert
Model Number: IM4
FCC ID: EHAIM4
Intermec Technologies Corporation
th
6001 36 Avenue West
Everett, WA 98203 USA
(425) 348-2600
Page 1 of 1