Related Manuals for Jobsite V-T8
Summary of Contents for Jobsite V-T8
- Page 1 INSTALLATION & USER GUIDE For Parallel Signal Distribution to Multiple Volume Controls V-T8 VOLUME CONTROL CONNECTION TERMINAL...
-
Page 2: Table Of Contents
V-T8 VOLUME CONTROL CONNECTION TERMINAL TABLE OF CONTENTS Features...1 Product Overview...2 Package Contents ...3 Preparing for Installation...3 Installation...5 Specifications ...6 Warranty...7... -
Page 3: Features
FEATURES Distributes audio signals for eight speaker pairs Reduces wiring clutter Installation friendly design: Accepts up to 14-gauge wire Snap and lock connector secures wire in place without the use of a screwdriver Mounts in 6" center structured wiring cabinets with the provided Christmas tree snap-in plugs Wings allow for either vertical of horizontal mounting... -
Page 4: Product Overview
PRODUCT OVERVIEW Speaker outputs to Amplifier input volume control Speaker outputs to volume control Snap-in “Christmas tree” plugs Figure 1... -
Page 5: Package Contents
CAUTION! Every speaker pair in the system must be connected to an impedance-magnifying volume control and set to the same magnification. When you install the V-T8 and connect the volume controls to it, double-check the DIP-switches on the volume controls to verify that they are set correctly for the impedance load of your speakers. - Page 6 Figure 2 Figure 3 Some speakers have selectable impedance. Before you proceed, please confirm that any selectable- impedance speakers in your system are properly set for the system you are installing. 1. Count the number of pairs of 4 ohm speakers and the number of pairs of 8 ohm speakers you are connecting.
-
Page 7: Installation
INSTALLATION 1. Select an appropriate location for the V-T8. 2. Run all the necessary wiring to the V-T8. Label the wires for future reference. 3. Strip 1/4" of insulation from the end of each wire. Tightly twist the end of each wire until no frayed ends remain. -
Page 8: Specifications
6. Insert each wire into the appropriate hole and snap down the locking tabs. 7. Insert the smooth side of the connector plug into the smooth side of the V-T8 socket. 8. Connect the amplifier to the connector terminal labeled: INPUT FROM AMP. -
Page 9: Warranty
This Warranty is subject to the following additional conditions and limitations. The Warranty is void and inapplicable if JOBSITE deems that the product has been used or handled other than in accordance with the instructions provided by the manufacturer,... - Page 10 If the above conditions are met, the purchaser’s sole remedy shall be to return the product to JOBSITE, in which case JOBSITE will repair or replace, at its sole option, the defective product without charge for parts or labor. JOBSITE will...
- Page 11 NOTES ____________________________________________________________________________________ ____________________________________________________________________________________ ____________________________________________________________________________________ ____________________________________________________________________________________ ____________________________________________________________________________________ ____________________________________________________________________________________ ____________________________________________________________________________________ ____________________________________________________________________________________ ____________________________________________________________________________________ ____________________________________________________________________________________ ____________________________________________________________________________________ ____________________________________________________________________________________ ____________________________________________________________________________________ ____________________________________________________________________________________...
- Page 12 WWW.JOBSITESYSTEMS.COM © 2004 JobSite Systems. All rights reserved. JobSite, Pure Custom and Niles are registered trademarks of Niles Audio Corporation and the JobSite Logo is a trademark of Niles Audio Corporation. All other trademarks are the property of their respective owners. Some JobSite products (or components thereof) are manufactured under one or more U.S.
Need help?
Do you have a question about the V-T8 and is the answer not in the manual?
Questions and answers