About Your Projector; Remote Control - Panasonic PT-LMZ460 Operating Instructions (Functional Manual)

About your projector

Remote control

1
2
3
4
5
6
7
8
1 Power <v/b> button
(v: Standby, b: Power on)
Sets the projector to the state where the projector is switched
off (standby mode). Also starts projection when the power is
switched off (standby mode).
2 Input selection buttons (<HDMI1>, <HDMI2>,
<COMPUTER1/2>, <NETWORK/USB>)
Switches the input signal to project. (x page 51)
3 <MENU> button/<RETURN> button / <ENTER> button/
asqw buttons
Used to navigate through the menu screen. (x page 61)
asqw buttons are also used to enter the password in
[SECURITY] or enter characters.
4 <VOL-> button/<VOL+> button
Adjusts the volume of the built-in speaker or audio output.
(x page 54)
5 <SCREEN ADJ> button
You can extend the projection distance via the Digital Zoom
Extender function or correct various types of distortion in a
projected image. (x page 55)
6 <FREEZE> button
Used when pausing the image and turning off the audio.
(x page 55)
7 <P-TIMER> button
Operates the presentation timer function. (x page 57)
8 <D.ZOOM +> button / <D.ZOOM -> button
Zoom in and out the images. (x page 56)
9 Remote control signal transmitter
Attention
f Do not drop the remote control.
f Avoid contact with liquids or moisture.
f Do not attempt to modify or disassemble the remote control.
f Please observe the following contents that are described on the back of the remote control unit (see the picture below).
g Do not use a new battery together with an old battery.
g Do not use unspecified batteries.
g Make sure the polarities (+ and -) are correct when inserting the batteries.
In addition, please read the contents that are related to batteries in the "Read this first!".
Chapter 1 Preparation - About your projector
9
10
11
4
12
13
14
15
16
17
10 <AUTO SETUP> button
Used to automatically adjust with auto setup function while
projecting the image. (x page 55)
11 <CEC> button
Displays the HDMI-CEC operation screen. (x page 93)
12 <SHUTTER> button
Used to turn off the audio and video temporarily. (x page 54)
13 <MUTE> button
Used to temporarily mute the projector. (x page 54)
14 <STATUS> button
Displays the projector information. (x page 58)
15 <ASPECT> button
Switches the aspect ratio of the image. (x page 57)
16 <DEFAULT> button
Resets the content of the sub-menu to the factory default.
(x page 62)
17 Number (<0> ~ <9>) buttons
Used for entering a password or an ID number in a multiple
projector environment.
18 <FUNCTION> button
Assigns a frequently used operation as a shortcut button.
(x page 57)
19 <ID ALL> button
Used to simultaneously control all the projectors with a single
remote control in a multi-projector environment. (x page 58)
20 <ID SET> button
Sets the ID number of the remote control in a multi-projector
environment. (x page 58)
18
19
20
ENGLISH - 27