How To Operate Your Ice Maker; Control Panel; Cleaning And Maintenance - Salton SIMM12 Instructions And Warranty

HOW TO OPERATE YOUR ICE MAKER

NOTE: Water reservoir and pipeline should be well cleaned before use.
1. Open the lid and take out the ice basket.
2. Add water to the reservoir.
3. Note: There is a maximum scale (MAX) in the reservoir. The water should not exceed the
MAX level. If the water exceeds the maximum level (MAX), you need to open the bottom drain
plug and release the excess water.
4. Plug the machine in and press the POWER button to start the machine.
5. When the ice basket is full, please take out the ice immediately, do not allow the ice to
overflow.

CONTROL PANEL

1. ICE FULL: Ice full indicator
2. ADD WATER: Water shortage indicator
3. ICE MAKING: Ice making indicator
1. The indicator light-POWER will flash after ice machine has been plugged in, press POWER
and the machine will start making ice automatically. The ice making indicator light will always
be on during operation.
2. When the "ADD WATER" light is on, it means that there is a water shortage in the water tank. -
-You need to add water and press the POWER button to restart the machine.
3. When the ice reaches the max storage capacity, the indicator light of the ICE FULL button will
light up and the machine will stop operating.
-Please empty the ice from the ice basket and add water if required and restart your ice
making process.
4. -If the level of ice is lower than the position of ice basket full sensor, the machine will restart
automatically.
CLEANING & MAINTENANCE
5