Switching Off Water Softening - Siemens SE63HX36TE User Manual

NL Softening System
Open the lid of the softening salt
1.
reservoir and remove it.
When using for the first time: fill
2.
the reservoir completely with water.
Remark: Only use special salt
3.
for dishwashers.
Do not use salt tablets. Do not
use table salt.
Place the softening salt in the
softening salt reservoir.
Funnel
1
Fill the water softening salt
reservoir completely with softening
salt. The water in the reservoir is
displaced and flows away.
Fit and close the lid of the
4.
reservoir.
Depending on the device version
1
24
Switch off water softening
If the refilling salt display bothers you,
for example if you use a combined
dishwasher detergent with a salt
component, you can switch off the
display.
Remark
To avoid damage to the appliance,
only switch off the water softening
in the following cases:
s The water hardness is maximum
a
s The water hardness is 0 - 6
1.
2.
a The display shows Hxx.
a The display shows
3.
4.
a The water softener has been
times 21 °dH and you use a
combined dishwasher detergent
with salt substitutes. According to
the manufacturer's instructions,
combined dishwasher detergents
with salt substitutes can only be
used up to a degree of hardness of
21 °dH without adding softening
salt.
°dH. You do not need to use
softening salt.
on to press.
Approx. 3 seconds on
to access the basic settings.
to give.
Press as many times until
the display shows H00.
To save the settings, press for
approx. 3 seconds.
switched on and the refilling salt
indicator is deactivated.
Busy-