Table of Contents
Advertisement
Available languages
Available languages
7
11
12
13
16
14
15
Assembly
1.
Tighten stand tube to stand base with screw.
Unscrew the out-joint, put the base cover on the
stand base. Pull the extension pole out, then tighten
the out-joint again. Place control box firmly on top of
extension pole, tighten screw (11).
2.
Unscrew the blade cap by turning clockwise and rear
guard mounting nut by turning counter clockwise.
3.
Put rear grille on motor shaft and secure with guard
nut.
4.
Slide blade on motor shaft.
5.
Screw blade cap on shaft by turning counter
clockwise.
6.
Put front grille on rear grille and close clips or screw
grille ring to secure grilles together.
5
2
6
9
4
10
8
3
1
17
EN
2
Advertisement
Table of Contents
