Using The Appliance - Faber R4388 Instruction Manual

CAUTIONS

USING THE APPLIANCE : -

1. Connect the mains plug into an earthed wall socket.
2. Carefully pull the pan out of the Hot-air fryer (Fig.6)
3. Put the ingredients in the grill. (Fig.5)
4. Slide the pan back into the Hot-air fryer (Fig 4)
Noting to carefully align with the guides in the body of the fryer.
Never use the pan without the grill in it.
Caution: Do not touch the pan during and some time after use, as it gets
very hot. Only hold the pan by the handle.
5.Determine the required preparation time for the ingredient
( see section 'Settings' in this chapter).
6.Some ingredients require shaking halfway through the preparation time
(see section "Settings" in this chapter). To shake the ingredients, pull the pan
out of the appliance by the handle and shake it. Then slide the pan back into
the air fryer
Tip: To reduce the weight, you can remove thegrill from the pan and flip the
ingredientson the grillonly. To do so, pull the pan out of the appliance, place
it on a heat-resistant surface and lift the grill out of the pan
Tip: If you set the timer to half the preparation time, you hear the timer bell
when you have to shake the ingredients. However, this means that you have
to set the timer again to the remaining preparation time after shaking.
7. When you hear the timer bell, the set preparation time has elapsed. Pull
the pan out of the appliance and place it on a the trial framework.
Note: You can also switch o the appliance manually. To do this, turn the
time control knob to 0.
8. Check if the ingredients are ready.
If the ingredients are not ready yet, simply slide the pan back into the appliance
and set the timer to a few extra minutes.
9. To remove ingredients (e.g. fries), pull the pan out of the Hot-air fryer and
place it on trial framework and and lift thegrill out of the pan