MALTEC Turbo ClimaControl CC2000M Instruction Manual page 10

Function Control Panel
1. ON/OFF: Press the "ON" button on the control panel or press the ON/OFF button
on the remote control to turn the unit on. The unit will start at intermediate speed and
then drop to slow speed. To switch back to the standby position, simply press the
OFF button on control panel or press the ON/OFF button on the remote control.
2. Speed: Wind speed can be adjusted to 3 levels as low---med—high by pressing
the 'Speed' button. Each time the 'Speed' button is pressed, an icon will appear on
the LED screen indicating the current speed level.
3. Wind: Press the 'Wind' button to choose the wind type. Each time this button is
pressed, an indicator will light on the screen to indicate the type of wind. There are 3
types of winds to choose： Normal—Natural—Sleep
4. Timer: Press 'Timer' button to set the fan running time between 1-7 hours, which
switches the unit to standby after preset time. Each time the button is pressed, the
hours will increase one by one and the time indicator will light on the screen. Timing
1 hour, display 1 H.Timing 2 hours, display 2 H. Timing 3 hours, display 2H and
1H.Timing 4 hours, display 4H. Timing 5 hours, display 4H and 1H. Timing 6 hours,
display 4H and 2H. Timing 7 hours, display 4H, 2H and 1H.
5. Swing: Press 'Swing' button to change the wind direction. The swing icon will
appear on the screen when the function is activated. Press the button again to stop
the oscillation. The vertical direction of air flow can be adjusted manually by directing
the outlet louvers up and down.
6. Cooler: To activate the air cooler function, please press the 'Cooler' button. Water
pump will take the water from the tank and pour it onto the cooling pad. Cooling pad
absorbs the heat of the water and the evaporated air is blown out by the help of fan.
The cool breeze blown by the cooler drops the temperature and creates a relaxing
Assembly of the Air Cooler
1. Open the package and take out the air cooler, wheels, place the fan on a flat
ground.
2. Installation of Wheels: Take out the screw package, fixing the wheels with screw
by cross screwdriver. Two wheels with brakes should be installed at the back holes
and the other two wheels to the front holes.(Fig.-1)
3. Filling Water: Turn the water tank lock to horizontal position, taking out the water
tank, put in the ice boxes and add clean tap water to large section of the tank (Fig.-
2). Be sure that water level in the tank does not exceed the level "MAX" which is
located at the back of the tank.(Fig.-3)
Your cooler takes water from narrow section of the tank and pumps it on the cooling
pad. The water flowing through the cooling pad spills down to the large section of the
tank. This cycle causes water to absorb dust and dirt in the air. The filter at the
middle of the tank filters and cleans the water, therefore it should be attached to its
place while the device is operating.
10/19