Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Taramps Tarsafe TW10
Summary of Contents for Taramps Tarsafe TW10
- Page 1 TW10 / TW10 SB Without Lock MANUAL AUTOMOTIVE ALARM...
-
Page 2: Before Starting
1) Before Starting ATTENTION: We recommend the complete reading of this manual before proceeding with the installation of this product. This product is intended to make it porevent or inhibit the theft of the vehicle, as well as robbery of •... -
Page 3: Remote Control Functions
Illustrative images, which may differ from the real image. Control Functions (Manufactured from June 2019) - Anti Jammer Function. EXCLUSIVE IN THE G4 TARAMPS LINE. Jammer is when there is another control transmitting near the central of the alarm, making it impossible to turn the alarm on or off... -
Page 4: Operation
6) Lock by Secret Button - required to be enabled by master. (TW10 only) Operation: With the ignition on and the doors closed, press the master key for 1 second. Otherwise, Secret Button Lock will be enabled. After the programmed time, (according to the Beep 7 setting), the ultrasound LED starts blinking, the audio system will be turned off, the siren and turning lights will go off, another 20 seconds, the engine will begin failing until it is definitively Locked .To cancel the lock, press the master. -
Page 5: Ultrasound Sensors
8) Ultrasound Sensors Attach the sensors to the vehicle's windshield, 10cm below the roof. Ultrasound Sensors come with digital sensitivity adjustment. Only change the default setting if necessary. Follow the table below: Sensors Sensitivity Click Alarm Response +20% 1 time 1 Beep 2 times +10%... - Page 6 9) Window Activation Setup: Configure Signal to trigger window / Lock - With the door open, switch on the ignition. Configure - Hold the master pressed until beep 8. Select the Beep 8 function - The alarm will respond informing: START 1 Beep = Universal 1X = Universal...
-
Page 7: Relay Connections
9) Window Connections and VW G6 and G7 Electric Lock (continuation) Function: Closes and opens the power windows, locks and unlocks the doors. Window activation signal setting = VW G6 / G7, item 8 To open the windows, turn the alarm off and hold down the off button on the control. ORIGINAL CENTRAL VW G6 / G7 Located above the fuse box... -
Page 8: Alarm Functions
10) Auxiliary Output Setting- brown wire Programming by Master CONFIGURE - With the door open, turn on the ignition. Select Function Beep 10 - Hold the master pressed until beep 10. START -The alarm responds with the current setting : 1 Beep = Reads Negative switch 1X = Door - 2X = Door +... -
Page 9: Select Function
12) Programming by Master Key With the door open, turnon the ignition and hold the master pressed until the desired function beeps. The alarm will beep according to the current setting, to change, press the master the number of times of the desired setting. -
Page 10: Installation Scheme
Installation Scheme Attention: The G4 ALARMS LINE has a new Ultrasound transmitter . In case of replacement of the old alarm panel by G4, the sensortransmitter, (right side sensor, no LED) must also be replaced by the new one Master Key 5 - Black Fix to the vehicle’s windshield, 10cm below the ceiling 7 - Red... -
Page 11: Warranty Term
24 months from the date of purchase. In the event of a defect within the warranty period, TARAMPS' liability is limited to repairing or replacing the device manufactured by it. • Products damaged by incorrect installation, water infiltration, tampering by unauthorized individuals;...