Electrical Connection; Water Connection - AEG LR8E70480 User Manual

SAFETY INSTRUCTIONS

2.2 Electrical connection

WARNING!
Risk of fire and electric shock.
• WARNING: This appliance is designed to be installed /
connected to a grounding connection in the building.
• Always use a correctly installed shockproof socket.
• Make sure that the parameters on the rating plate are compatible
with the electrical ratings of the mains power supply.
• Do not use multi-plug adapters and extension cables.
• Make sure not to cause damage to the mains plug and to the
mains cable. Should the mains cable need to be replaced, this
must be carried out by our Authorised Service Centre.
• Connect the mains plug to the mains socket only at the end of the
installation. Make sure that there is access to the mains plug after
the installation.
• Do not touch the mains cable or the mains plug with wet hands.
• Do not pull the mains cable to disconnect the appliance. Always
pull the mains plug.

2.3 Water connection

• The inlet water shall not exceed 25 °C.
• Do not cause damage to the water hoses.
• Before connection to new pipes, pipes not used for a long time,
where repair work has been carried out or new devices fitted
(water meters, etc.), let the water flow until it is clean and clear.
• Ensure that there are no visible water leaks during and after the
first use of the appliance.
• Do not use an extension hose if the inlet hose is too short.
Contact the Authorised Service Centre for the replacement of the
inlet hose.
10/96