Advertisement
Quick Links
Advertisement
Related Manuals for LS&S 101165
Summary of Contents for LS&S 101165
- Page 1 TALKING ATOMIC WATCH INSTRUCTIONS （US） Basic Button Functions:...
- Page 2 Please retain this instruction manual for future reference. You may need this to re-adjust the time if required or when you are traveling to some other countries with no atomic signal’s reception for your watch. Your talking watch is a single band Radio controlled watch.
- Page 3 4:00AM. BEFORE THE FIRST USE PLEASE SET YOUR TIME ZONE Time Zone Setting: Hold the 8 0'clock button for more than 3 seconds. The watch will speak. Push the 8 0'clock button another 3 times in a row, until the watch says "Time Zone Setting"...
- Page 4 Press the 8 o'clock button to confirm your selection Manual Signal Reception: Please ensure the watch is in correct Time Zone before initiating Manual Signal Reception. Press and Hold the 10 0'clock button about 3 seconds until the signal icon ) flashing.
- Page 5 If reception failed, the watch will say "USA Time not updated." * If you unable to get the signal at the first time, you may move the watch to another location where the reception may be more favorable and try manual reception again or wait overnight for better possible reception.
- Page 6 IMPORTANT NOTE: IF YOUR WATCH DOES NOT SYNCHRONIZE THE TIME WITH THE ATOMIC TOWER IN THE FIRST ATTEMPT, TRY IT FEW MORE TIMES SINCE THE SYNCHRONIZATION DEPENDS ON THE CLEAR SIGNAL RECEPTION AND ATOMIC TOWER LOCATION. TRY THE ABOVE TWO METHODS AT DIFFERENT LOCATIONS AT ONE PARTICULAR POINT.
- Page 7 WATCH AWAY FROM THESE DEVICES FOR TIME SYNCHRONIZATION Manual Time Setting: You should use this function if traveling to countries with no signal reception. You must also set the correct time of day (AM/PM) and time zone when you come back from travel to other countries.
- Page 8 The watch will instruct you how to set the time: Press the 2 0'clock button to set the hour. Listen very carefully to the watch to make sure the right AM or PM has been set (if you set the wrong AM/PM, your watch will not be able to pick up signal at 3.00 AM).
- Page 9 Press the 10 0'clock button once. The watch will instruct you how to set the time. Press the 2 0'clock button repeatedly to set Hour. Next press 4 0'clock button repeatedly for Minutes. Press the 8 0'clock button to confirm after you have set the Alarm time.
- Page 10 permanently turn off the daily Alarm. you can follow the Alarm ON/OFF instructions below. (After the 30 seconds of Beeping, the watch will speak the Alarm Time). Alarm ON/OFF Hold the 8 0'clock button mode for more than 3 seconds until the watch says "Set Alarm……"...
- Page 11 If the alarm is OFF, the watch says: "Alarm is OFF". If the Alarm is ON the watch says, "The alarm time is …."(followed by the alarm time has been set). Hourly Chime Settings: Hourly Announcement (Chime) ON/OFF ...
- Page 12 Press the 10 0'clock button once. Press 2 o’clock button to turn ON Chime Alert, Press the 4 0'clock button to turn OFF Chime Alert. Press the 8 0'clock button to confirm. Watch Not Receiving Time Signal: Reasons for not being able to receive the Time Signal include: -Being outside of the country...
- Page 13 standard watch, The time will then be corrected the next time your watch receives the time signal. Low battery Detection: Battery Replacement: This watch uses a CR2032 type battery; trained jewelers or watch specialists should replace the batteries to avoid any damage to the watch.
- Page 14 make sure the seal is in place. After battery replacement the watch defaults to Pacific Time Zone. please set your Time Zone as necessary.
Need help?
Do you have a question about the 101165 and is the answer not in the manual?
Questions and answers