LS&S 101164 Instruction Sheet

To Wake Up The Watch

 If the watch hands stopped at 1 o'clock when you receive the watch at the first time, it means the
watch now is in sleep mode. Press and hold 2 and 4 o'clock buttons simultaneously for 3 seconds
to resume normal running.
 The hands will spin to match the internal time. Wait until the watch resume normal running.

Enter Sleep Mode

 While the watch is running normally, press and hold 2 o'clock button and 4 o'clock at the same
time until the second hand is fast spinning.
 Release all buttons. And wait the hands spinning until it stops at 1 o'clock.

Features

 Your analog talking watch is a single band Radio controlled watch. The National Institute of
Standards and Technology (NIST) radio station, WWVB, located in Fort Collins Coloado,
continuously broadcasts the time signal at 60 KHz.
 This signal can be received up to 2000 miles away, anywhere in the continental USA where long
wave (AM)radio reception is possible.
 The WWVB station derives its signal from the NIST Atomic Clock in Boulder, CO which will
automatically update your atomic watch's time and date as well as adjust for daylight savings time.
 Your Analog talking radio-controlled watch recalls your selected Atomic Clock signal automatically
at 3:00AM every night. After reception of signal, it will show the official local time on the watch.
Everything is done automatically. However, your watch can also be manually set.
BEFORE THE FIRST USE PLEASE FOLLOW BELOW DIRECTIONS TO SET YOUR TIME ZONE.

Button Functions:

2 o'clock button
 Press 2 o'clock button for time announcement.
 Press 2 o'clock button 2 times for day and date announcement.
 Press 2 o'clock button 3 times to hear reception status. If the reception was successful, the watch
will say "Country name "follow by "Time Updated". If the reception was failed, the watch will say
"Country name" follow by "Time Not Updated"
4 o'clock button
Push 4 o'clock button once to check alarm time setting and if the alarm is set to ON or OFF (the
watch says the alarm time follow by "Alarm is ON" or "Alarm is OFF")
Crown：
Use to reset all hands to 12:00:00 position. When the crown is pulled out, the watch stops
immediately.

Time Zone Setting:

To receive the correct time, you first need to set your Time Zone:
 Hold 4 o'clock button for at least 5 seconds while the watch is in normal running mode.
 Once the watch speaks, hit the 4 o'clock another 3 times, until the watch says "Time Zone Setting,
press 2 o'clock button to set......" now press 2 o'clock.
 The watch will instruct you to hit the 2 o'clock button again to select a time zone and hit 4 o'clock
Analog Radio-Controlled Talking Watch
Instruction Sheet