Page 2
Sportsband Bluetooth headphones Charging the headphones Charging the battery before use is recommended but not required. The headphones ship pre-charged however initial charge will vary. Low battery is indicated by the status indicator blinking red with an audible tone every 20 seconds. Charging the battery with USB cable Connect charging cable with the charging port of headphones below the control panel of the right earpiece.
> Need more words for pairing? See next page if simple just isn’t simple. Skip it if you’ve got it down. Begin with SB1 powered o . Push and hold multi-function button for 6 seconds until status light alternates red and blue. You are now in pair mode.
Page 4
After searched, select “SB1” in the Bluetooth device list. 4. Enter password or PIN No:”0000” on your mobile phone when prompted. 5. If required, after successful pairing, select “SB1” in the Bluetooth device list and press “connect”. 6. After successful connecting, the blue light blinks twice every 4 seconds.
Page 5
Sportsband Bluetooth headphones Pairing with several Bluetooth devices The headphones can connect with two devices at most. A mobile phone with HFP profile; and a device with A2DP profiles. If you want to pair two Bluetooth devices, please refer to the following steps. 1.
Page 6
Bluetooth headphones < > < > < > < > < > < > Play Pause Answer Call Increase Volume Decrease Volume Previous Track (iPhone does not support this feature) Next Track (iPhone does not support this feature) Reject Incoming Call Voice Dial (Use Voice dail with iPhone for next and previous track)
Page 7
Bluetooth headphones Making a call with the headphones (detailed operation) Function Status of headset Voice dial Standby mode Redial last number Standby mode Turn up volume Conversation mode Short press or Turn down Conversation mode Short press or volume Answer calling Ringing Reject calling Ringing...
Page 8
“transmit the sound through Bluetooth” in the “setting” of music play interface, and then choose “SB1” in the device list.Please refer to the instruction of your mobile phone for further information. When the volume of headphones is adjusted to max or min,you will hear a “Ding-Dong” tone. Remote control the function of next track, previous track, etc require your mobile phone to support AVRCP.
Page 9
Bluetooth headphones Status Light Charging LED indicator Red light is on Red light is off Pairing with a Bluetooth Device LED Indicator Red and blue light blink alternately Blue light (blue light will turn red if low power) blinks twice every 2 seconds. Blue light (blue light will turn red if low power,) blinks twice every 4 seconds Blue light blinks (blue light will turn red...
Do not drop the headphones. Do not use chemicals or detergent to clean the product. If the product fails to work please contact JayBird support at jaybirdgear.com Compliance This Bluetooth stereo headset complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This Bluetooth stereo headset may not cause harmful interference, and (2) it must accept any interference received, including interference that may cause undesired operation.
Always turn the volume down before use. Copyright 2009 JayBird Gear LLC. All rights reserved. JayBird, and the JayBird logo are trademarks of JayBird Gear LLC. Bluetooth is a trademark owned by Bluetooth SIG, Inc. USA, and licensed to JayBird GearLLC. iPhone is a...
Need help?
Do you have a question about the Sportsband SB1 and is the answer not in the manual?
Questions and answers