Table of Contents
Advertisement
5.2 Switch off the device
(1) Turn off the marking software, exit the system according to the normal program
and turn off the power of the computer and monitor.
(2) Turn off the galvanometer power switch
(3) Turn off the laser power switch
(4) Turn off the main power switch
5.3 Brief description of software adjustment
Generally, when using the device, the user only needs to adjust "speed" / "power" /
"frequency" / "pulse width" in the laser parameter column.
Marking speed: XXXX - the speed the user needs;
Power: set the laser's percentage power by laser software 1% - 100% adjustable
Frequency: Set the laser light output frequency of the laser device by laser software.
1---1000KHZ adjustment
Pulse width: according to the laser type, marking effect requirements, set different
pulse width
For details on the operation of other parameters of the software, please read the
laser software instructions.
Chapter 6 The Maintenance
The fiber laser marking machine is mainly composed of electronic components,
precision instruments and optical components, and has high requirements for the
use environment and daily maintenance.
6.1 Precautions for maintenance of the machine
1) When the unit is not working, turn off the marking machine and computer power.
2) When the unit is not working, cover the field lens lens to prevent dust from
contaminating the optical lens.
3) When the machine is working, the circuit is in a high voltage state. If it is not a
professional, do not overhaul it during start up to avoid electric shock.
4) If there is any malfunction of the unit, the power should be turned off
immediately.
5) When the equipment is used for a long time, the dust in the air will be adsorbed
on the lower surface of the focusing mirror. The lighter will reduce the power of the
laser and affect the marking effect; if the lighter causes the optical lens to absorb
heat and overheat, it will burst. When the marking effect is not good, you should
carefully check the surface of the focusing mirror for contamination.
If the surface of the focusing mirror is contaminated, the focusing mirror should be
removed to clean the lower surface.
Care should be taken when removing the focusing mirror, taking care not to damage
or fall; at the same time, do not touch the focusing mirror with your hand or other
objects.
Advertisement
Table of Contents
