Download Print this page

Automated Logic MX800 Technical Instructions

Download this manual

Technical Instructions

MX800

Using the MX800 2

Specifications 2

Mounting 3

Addressing 3

Power Wiring 3

Digital Outputs 3

Channel Numbers 4

Troubleshooting 4

LEDs 4

Protection 5

Production Date 5

Automated Logic Corporation • 1150 Roberts Blvd. • Kennesaw, GA 30144 • 770/429-3000 • 770/429-3001 Fax •

Automated Logic logo, SuperVision, Eikon, and Alert are registered trademarks of Automated Logic Corporation.

InterOp is a trademark of Automated Logic Corporation. BACnet

and product names are trademarked by their respective companies.

is a registered trademark of ASHRAE. All other brand

Need help?

Do you have a question about the MX800 and is the answer not in the manual?

Page 1 Protection 5 Production Date 5 Automated Logic Corporation • 1150 Roberts Blvd. • Kennesaw, GA 30144 • 770/429-3000 • 770/429-3001 Fax • www.automatedlogic.com • Copyright 2000 Automated Logic Corporation. All rights reserved. Automated Logic, the Automated Logic logo, SuperVision, Eikon, and Alert are registered trademarks of Automated Logic Corporation.
Page 2 By attaching the MX800 radio communications. Operation of this expander to M or Mcpu controllers, your...
Page 3 4. Apply power to the transformer. The MX800 uses a rotary switch to assign the module’s expander number. If the module’s 5. Make sure that 24VAC is present at the expander address is three, set the switch to module’s power input terminals.
Page 4 Be sure the MX800’s power is off before each switch a digital input in the FB using wiring any inputs or outputs. Connect the channel numbers 81 through 88. Channel 81 output wiring to the screw terminals on the corresponds to HOA switch number one;...
Page 5: Production Date
Digital Output Status - lights when the digital output is activated. Protection The MX800 module is protected by internal solid state Polyswitches on the incoming power. These Polyswitches are not replaceable and will reset themselves if the condition that caused the fault returns to normal.