Korg Karma Product Support & Faq page 2

Each line of this screen represents a different insert effect. There are a total of five inserts that can be set
up:
6. Using the value slider, buttons or dial, select an effect of your choice for "IFX1".
7. Press the left < cursor button once to highlight the "Off" field
8. Using the value wheel change it to "On".
Now, we can set tracks to use that effect. Again, let's use track 1 as our example:
9. Press the F7 "Route" tab. Notice that track 1 is already selected (Darkened) at the bottom of the screen.
Using the value slider, wheel or buttons, make a "connection" to insert effect 1 – This will be indicated
by a line drawn from "1" to "IFX1".
Now, we need to route the Insert Effect to the desired output.
10. Press the Setup (F1) tab. You will again see the list of Insert Effects being used.
11. IFX1 is still selected since we were working with it before. From here, press the right > cursor button
until you have selected "L/R" on the screen. This is the "BUS Select" as indicated at the top right hand
side of the screen.
12. Much like in our previous example, using the value wheel or the Inc or Dec buttons, select "1" which
sends the effect, and the programs it is being used on, to output "INDIV 1".
Repeat steps 2 and 3 for each insert effect you wish to route to an output.
NOTE: Most of the Insert effects are stereo, this in mind, you can keep the effects stereo by selecting a
dual output routing. In other words, in addition to choices like "1" and "2" there is also a paired
choice; "1/2", which allows the sound to come out of two outputs. This is a stereo pair, and will keep
stereo effects intact.