Table of Contents
Advertisement
Electrical Supply Circuit Requirements
Plan the location of the appliance so that it will have adequate electric power. A 15 AMP, 120V/60Hz
circuit is required. Additional appliances on the same circuit as this appliance may exceed the current
rating of that circuit.Please dedicated circuit is preferred to prevent circuit breaker trips or fuse
failure.
Prepare the outlet close to the right side of appliance. Make sure the outlet is in good condition and
the plug must be plugged tightly in the outlet.
For hard wiring, please refer to page 12 to 13
Note:
The glass panel should be placed in a safe place to avoid damaging before the Installation.
4A、Flush Mounted Installation
4A、Flush Mounted Installation
4.A1) Dimensions for all sizes are below,
The appliance listed will be is supported by the
bottom framing. Make sure the bottom framing is
solid and level. Leave some gap behind the right
stud for electrical supply.
The flush mounted height is reserved 16-1/4"(413mm),
The flush mounted depth is reserved 4-1/2"(114mm),
The flush mounted length A1 is reserved as follows:
Model
30"
No.
SUM-30-056
Inch
27.95
mm
710
Fix the plasterboard to edge of the framed
4.A2)
opening. Allow 3/4" (19mm) of the wood at
two sides exposed for fixing the brackets.
If you want to stick ledge stone on
plasterboard, you would add one more
wood on each side what has same
thickness as your ledger stone.
36"
42"
SUM-36-058
SUM-42-060
33.94
39.92
862
1014
50"
60"
SUM-50-062
SUM-60-064
47.95
57.95
1218
1472
72"
SUM-72-066
69.92
1776
- 7 -
Advertisement
Table of Contents
