Vissani VDH35 Use And Care Manual page 8

Operation (continued)
TIMER
To set Timer for a 30-minute to 24-hour delay before the dehumidifier is turned off (the dehumidifier must be On):
□ Press TIMER. Timer indicator light will come on, and the display will flash. The display will show remaining time
before the dehumidifier wiII turn off.
□ Press the Plus or Minus button to change the delay time, from 30 minutes to 24 hours.
To set Timer to turn on the dehumidifier, with previous setting:
□ Turn off the dehumidifier.
□ Press TIMER. Timer indicator light will flash. The display will show remaining time before the dehumidifier will turn
on.
□ Press the Plus or Minus button to change the delay time, from 30 minutes to 24 hours.
To clear the Timer delay program:
□ Press TIMER once after it has been programmed. Display will show remaining time. While the display is showing the
remaining time, press TIMER again. Timer indicator light will turn off.
NOTE: Dehumidifier can be either on or off.
To see the remaining time:
□ Press TIMER once after it has been programmed. Display will show remaining time.
NOTE: Empty the water bucket before setting the timer function. If the water bucket becomes full
during the Timer function, the Empty Bucket light goes on and dehumidification stops.
□ When the Clean Filter indicator light is on,remove, clean and replace the air filter. See "Cleaning the Air Filter".
□ Press the Clean Filter button to reset the filter monitor.
NOTE: When the light is on, it will remain on for 180 hours or until you press Clean Filter button.
2
Normal Sounds
When your dehumidifier is operating normally, you may hear sounds such as:
□ Air movement from the fan.
□ Clicks from the thermostat cycling.
□ A high-pitched hum or pulsating noise caused by the high-efficiency compressor cycling on and off.
8