Advertisement
4 E. AUDIO HD/SD SDI signal input terminals (IN 1, IN 2)
Accepts an HD SDI signal and an SD SDI signal.
Also accepts EMBEDDED AUDIO signals including up to 8 audio channels with the
sampling frequency of 48 kHz.
Select input by using the button on the monitor.
Select IN 1 terminal: INPUT C (SLOT-1)/E (SLOT-2)
Select IN 2 terminal: INPUT D (SLOT-1)/F (SLOT-2)
About the audio level meter function
Use the audio level meter display to see the status of the EMBEDDED AUDIO
signals currently being input. Use the "AUDIO SETTING" on the main menu of the
monitor to set the audio level meter display on or off, and its various settings. Refer
to your monitor instruction manual for more information.
NOTE:
• The type of signal coming through the IN 1 and IN 2 terminals is automatically recognized—HD
SDI or SD SDI signal. Note, however, that input lines are not changed automatically.
5 Label (see page 5)
1 On the rear panel: Place the label on the name of the slot into which you have
installed the Input Card.
2 On the remote control: When the input signal type for input B is fixed (RGB,
COMPO., or DVI), place the corresponding label on the printing of the input select
buttons A and B.
3 On the remote control: Place the label on the printing of the input select buttons
(C/D or E/F) for the slot into which you have installed the Input Card. ("NO CARD" is
for a blank slot.)
6 Connection terminal (on the rear side)
Attach to the connection terminal in the slot of your monitor.
9
Advertisement
